Skip to content

VISA

V2 has no VISA interface and does not control measuring instruments.

Until 2026-09 this page described something else

It listed a VISA integration for V2: interfaces (GPIB, USB-TMC, TCP/IP, RS-232), a setup procedure and the automatic transfer of measurement data into the calibration record. There is no code for this in laravel/ or frontend-v2/, only the permission carried over from V1.

What Existed and Exists

In V1 there is a control page used to open, read, write and close VISA resources. The permission for it was carried over to V2 but only takes effect while V1 runs alongside.

In V2 there is no instrument control:

  • Manual measured values are recorded by the technician in the guided test procedure, see Test Steps.
  • Automated measurements run in Fluke MET/CAL. The results reach calServer through the synchronization with MET/TEAM or MET/CONNECT.